Cautions in the Use of UV Light Oil
  1. The normal operating temperature of UV gloss oil is 50-55 C. When used at low temperature in winter, the UV gloss oil needs to be heated in constant temperature water to achieve its designed viscosity, which is conducive to the leveling and rapid curing of UV gloss oil.
  2. In the UV polishing operation, if the skin is exposed to UV polish, it should be washed out with soap water, otherwise the skin may become reddish and swollen. UV varnish is photochemistry paint, which has a certain irritating odor. In the process of spraying UV varnish, please wear the necessary mask and so on.
  The main steps are as follows:
  Formed sheet surface polishing oil removal spraying UV varnish infrared leveling UV curing UV lamp UV curing Ultraviolet lamp irradiation, you can touch the surface without sticking to the hand, not illuminating for too long Receiving packaging
  The function of infrared leveling:
  (1) Make the paint level enough on the surface of the workpiece, so that the film can achieve the best fullness and freshness.
  (2) All the inactive thinners added to the paint during construction are volatilized to obtain good appearance and film performance.
  After infrared leveling, the paint surface of the workpiece will be instantly dried by UV drying process, which greatly shortens the drying time of the paint, so the production efficiency is greatly improved.
  Key factors: 1. UV paint spraying amount must be moderate, not too thick, otherwise, due to the reaction force of UV paint itself, the paint layer will crack; 2. Leveling and UV curing time must be mastered; 3. Sanding links are very important, must be carefully sanded, otherwise it may affect the adhesion between the substrate and the coating.
  First, the product should be used in conjunction with the UV lamp. The best UV curing machine with lamp power of 2000 to 3000 watts is recommended. Our shop provides high quality and low price UV curing equipment. If you need it, please consult customer service.
  2. Spraying or film-coating process is not grasped by novices. After ordering the product, it is necessary to master the spraying technique and curing time many times.
  3. The spray gun requires good atomization effect and better quality.
  4. Spray UV varnish, and install oil-water separator between air pump and spray gun.
  Spraying construction technology (spraying UV varnish):
  1. Artificial stone surface is roughly polished with abrasive discs or polished with 400 mesh water-borne abrasive paper. (Ceramic tile background wall pattern layer can not be polished)
  2. Clean the surface and remove oil with degreaser.
  3. Spray new UV varnish and two guns under normal conditions.
  4. Leveling. Place it naturally for 5-10 minutes on hot days. In cold days, heat the paint film to 50-60 degrees for 3-5 minutes.
  5. Rapid curing by irradiation with a UV curing machine (curing lamp) of more than 1 kilowatt.
  6. With a few defects, it can be polished and waxed.
  Coating construction technology (suitable for flat surface only, roll coated with UV varnish):
  1. Artificial stone surface is roughly polished with abrasive discs or polished with 400 mesh water-borne abrasive paper. (Ceramic tile background wall pattern layer can not be polished)
  2. Pour the UV paint evenly on one side.
  3. Cover the PET film and tighten it.
  4. Scraping UV paint repeatedly with scraper
  5. Curing with UV equipment
  6. Uncovering PET Film
  7. UV finish